CLIMATE TRANSMITTER PFT25
Climate transmitter PFT25
Measuring temperature and relative humidity with a „single-chip“-sensor
Fast response time
Digital transmission from sensor to the evaluation electronics
Additional computed values: dew point temperature, absolute humidity, wet bulb temperature and enthalpy
Analog outputs 0…10 V or 4…20 mA
Sensor interchangeability without need for re-calibration
Protection class IP 65
The climate transmitter PFT25 converts the directly measured values temperature and relative humidity into often used climatic values dew point temperature, absolute humidity, wet bulb temperature and enthalpy by digital calculation. The device has two analog outputs, output 1 is always set to temperature, whilst the second output can be set to 4 further values by a two stage dip-switch. The design of the PFT25 corresponds to the transmitter PFT22.
All measured and calculated values are shown with a resolution of 12 bits. For the calculation, a mean air pressure of 1000 hPa is used. To achieve maximum accuracy, the location of medium height and air pressure are given on the spot.
Operating mode:
Messuring mode
Medium:
Temperature and Humidity
Sensor:
Single-chip sensor for humidity and temperature with digital signal transmission and calibration memory on the chip
Measuring unit:
Temperature
Output signal 1:
Relative humidity, Dew point, wet bulb temperature, enthalpy
Output signal 2:
(Special range – absolute humidity)
Resolution:
14 bit
Response time:
Approx. 20 seconds
Reproducibility:
± 0,1 °C
Tolerance:
±0,5 °C at 25 °C; ±2 °C at -40 °C, ±3 °C at +120 °C; narrower tolerance possible
Measuring ranges:
-30…+50 °C
Characteristics:
Linear
Resolution:
12 bit
Response time:
Aprox. 4 seconds (63 %-time, slightly moving air)
Reproducibility:
Typical < 1 % r.h. / year
Tolerance:
± 0,1 % r.h.
Measuring ranges:
| Temperature: | T = -30…+50°C, 0…50°C, 0…100°C; |
| Relative humidity: | r.h. = 0…100% |
| Dew point: | dp = -30…+50 °C |
| Wet bulb temperature: | wbt = -30…+50 °C |
| Enthalpy: | E = 0…200 kJ/kg; |
| Absolute humidity: | a.h. = 0…50 g/kg |
Measuring range:
4 selectable measuring ranges via DIP switch
Characteristics:
Linear (digital linearization)
Dimensions:
See drawings
Connections head:
Plastic ABS
Electrical connection:
7 Connection terminals
Version differences:
| Channel sensor: | Sensor tube: stainless steel, 11 mm ø Protection class: IP 65 according to EN 60529 Cable gland: M16 x 1.5 |
| Outdoor sensor: | Sensor tube: double-walled sensor tube with wall holder Protection class: IP 65 according to EN 60529 Cable gland: M16x1.5 |
| Room sensor: | Plastic housing for mounting on a flush-mounted switch box or surface-mounted wall mounting |
Power supply:
15 … 30 Vdc or 24 Vac in three-wire circuit;
13 … 30 Vdc in two-wire circuit
Output current:
2 x 0 … 10 V in three-wire circuit;
2 x 4 … 20 mA in two-wire circuit
EMC:
EN 61000-6-2, EN 61000-6-3, CE-mark
RoHS:
according RoHS-directive 2011/65/EU
Are you interested?
Leave us a message and we will get back to you as soon as possible.